- Manufacturer: Laser
- Price: £19,995
- Location: Bursledon
- Year: 1988
- LOA: 28'0" (8.53m)
- Beam: 10' 0'' (2.90m)
- Berths: 6
- Draft: 1.4
- Keel: Fin Keel
- ID no.: 66F7966111
- Cabins: 2
- Heating: Diesel - Powered
- Heads: 1
- Watertank Size: 1 Litres
- Engine Make: Vetus
- Horsepower: 18hp
- Drive Type: Saildrive
- Fuel Type: Diesel
- Fuel Tank Size: 40 Litres
- Top Speed: 6 kn
A wonderful example of a highly competitive performance racer designed by the world-renowned Bruce Farr. She comes with an impressive sail wardrobe. The current owner has done extensive work on her since acquiring her in 2020.
Available For Viewing Six Days a Week Via Appointment Only, She Will Also Be Featured In The Deacons Used Boat Show (10th - 19th Sept)
Sleeps Six In Two Cabins Plus Saloon
Open plan interior
Newly upholstered with light grey Cordura fabric.
Wooden saloon table
Seats/bunks with storage underneath
Two hob gas burner
Mechanical and Rigging
The old engine and saildrive was removed and a new Vetus M2.18 engine with ZF saildrive was installed. At the same time, the fuel tank was replaced with a new polythene unit 40L.
The Standing Rigging was replaced in 2018
The Running Rigging is Dyneema.
Carbon Fibre Spinnaker pole
Carbon Fibre Asymmetric pole, in two parts. (The base socket is bonded to the hull whilst the pole stub slips into a female socket and is retained by a through bolt and Dyneema bobstay)
Goacher laminate Mainsail, 2 reefs, VGC
No 1 laminate Genoa VGC
No 2 Goacher laminate
No 3 Genoa North laminate
No 4 Genoa North
Asymmetric spinnaker Saunders
Symmetric spinnaker Light
Symmetric Spinnaker Heavy
Code 0 laminate NJO Sails 2021
Laser 28 Designed by world-renowned yacht designer Bruce Farr
An honest example of a performance racer
Moved to the owner's yard in 2020, put under cover then blasted with glass beads to open up any blisters. Washed twice with hot water pressure washer then left to dry for 5 months before epoxy coating the hull, then painting both above and below the waterline. The painting was completed with Grey epoxy paint and UV additive above the waterline and sprayed on antifouling onto the epoxy below the waterline.
Original plans from Bruce Farr's office were purchased for the keel profile, the keel was then stripped and faired to the original specification, being finished with epoxy undercoat and spayed on antifoul
(The keel matrix was repaired in 2018)
A new rudder and bearings from Jefa was installed
All wiring was replaced in 2020/2021 using tinned wire throughout.
Domestic and Engine starter batteries are new
All fittings and a charge control for the supply from the engine and a 240v system with a mains battery charger
All lighting is LED (except stern white light)
New Raymarine Axiom autohelm
New Micronet for MN100 instruments
New Simrad chart plotter (not supplied with current nav card)
New Cat B AIS
New DSC VHF
SeaDek (artificial gray teak)
Stern boarding ladder
The Company offers the details of this vessel in good faith but cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. A buyer should instruct his agents, or his surveyors, to investigate such details as the buyer desires validated. This vessel is offered subject to prior sale, price change, or withdrawal without notice.
Contact NYB Hamble
- Telephone: +44 (0)2382 120000
- Email: email@example.com
- Link to full office details
Disclaimer : boatpoint Ltd offers the details of this vessel for sale but cannot guarantee or warrant the accuracy of the information contained in the specification or warrant the condition of the vessel or equipment. A buyer should instruct his agents, or surveyors, to investigate such details as the buyer desires validated. This vessel is offered for sale subject to no prior sale, price change, or withdrawal without notice.